Categories
- Body Side Molding (7)
- Door Handles Cover (79)
- Door Sills (2)
- Head Light Bezel (6)
- L.E.D Head Light Bezel (10)
- L.E.D Tail Light Bezel (25)
- Tail Gate Trim (5)
- Mirror Cover (73)
- Mufflers (2)
- Rear Hatch (10)
- Sealed Beam (4)
- Tail Gate Handles (43)
- Tail Light Bezel (50)
- Window Sills (34)
- Pillar Post (77)
- Wheels (39)
- Contact Us (0)
- Installation (0)
Installation
| CHROME LED COVER INSTALLATION INSTRUCTIONS: |
| STEP ONE: Before you get started,make sure to test fit each piece to vehicle |
| before removing the protective fill of the 3m-tape. |
| STEP TWO: Grab the rubbing alcohol prep pad and clean the surface of the |
| Tail light or head light ,this will ensure the best adhesion of the new |
| chrome led cover to your vehicle |
| STEP THREE: Remove the 3M-Tape protective film and carefully align the cover then press |
| It firmly into place,make sure the cover has adhered completely to the vehicle. |
| STEP FOUR: Connect the POSITIVE(red cable)and the NEGATIVE(black cable)with clips |
| please affix the cables properly with the cable tie. |
| HEAD LIGTH: CONNECT TO PARK LIGTH OR TURN SIGNAL CABLE (+) |
| TAIL LIGTH : CONNECT TO PARKING LIGTH OR TURN SIGNAL CABLE (+) |
| NOTE: The ambient air temperature needs to be no less 60 degrees F (15 degrees C) |
| Or above for installation. |
There are no products to list in this category.